Sea
Tech fittings are a revolutionary way to set up your water system, using quick
connect fittings and universal tubing, rather than traditional barbed and threaded
fittings.
Imagine connecting your water lines using a combination of tubes, elbows and fittings that connect in a matter of seconds!
Sea Tech's 10 Series products are available in sizes 1/4", 3/8" and 1/2". Sea Tech offers quick connect fittings, valves, modular manifolds and tubing in this world class product offering. 10 Series products are manufactured in polypropylene and are made from FDA approved materials and certified to NSF-61. They are ideal for POU installations, drinking water systems, beverage service and water filtration applications.
FITTING PERFORMANCE RATING:
- 150psi @ 70°F (10 bar @ 20°C)
- 60psi @ 140°F (4 bar @ 60°C) Min. 33°F (1°C)
 |
Sea Tech connectors utlize a swivel nut with NPS straight threads and a cone seal. This allows the installer to thread onto NPT, NPS, BSP and most 1/2" male threads without tools or thread sealant. Simply thread on, hand tight, for a zero-leak seal. |
 |
Reducing Tees can be developed by simply snap fitting a Reducing Stem Connector into a Union Tee. |
 |
Sea Tech tubing is produced from a high performance, polyethylene material. Sea Tech Tubing is formulated and manufactured in 1/4", 3/8" and 1/2" OD sizes. 1/2" tubing is rated to 75psi. Sea Tech Tubing is NSF listed, FDA recognized and available in multiple colors for ease of water line identification. |
Installing Sea Tech fittings |
|
 |
Cut the tubing to length using the Sea Tech tubing cutter or similar. Inspect the outside diameter of the tubing. It must be free of damage, smooth, and clean. |
 |
Measure the insertion depth on the tubing end. Sea Tech connectors have a insertion depth line molded onto the outside of the connector bodies |
 |
Make certain to push the tubing completely into the connector until it comes into contact with the internal tubing stop. |
 |
To disconnect ensure the system is depressurized before removing connectors. Push the collet in squarely against the face of the fitting. With the collet held in this position, the tubing can be removed. The connectors can then be re-used. |